Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Bertazzoni specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 366-4775 Reserve a Visit
Model library · Bertazzoni Range

MAS304INMXV

Bertazzoni MAS304INMXV Induction Range Service

Bertazzoni range

Most common issues on this model

  1. A zone that will not heat, or switches on and off
  2. Two zones that will not join in bridge mode
  3. Touch panel that ignores you or registers touches you did not make
  4. Oven temperature sensor affecting how accurately it bakes

Most MAS304INMXV ranges stand in the standard 30-inch slot of a remodeled kitchen where the owner swapped gas for induction and installed a dedicated circuit. The Master Series styling is Italian, and the triple-glazed door keeps the front cooler during long bakes.

We check each of the four zones with a pan sized to the circle, and we watch for a zone that cycles on and off, which usually means overheating protection is stepping in. The bridge function is then tested by joining two zones under a large griddle pan.

The touch panel gets a careful look because moisture or residue on the glass can cause ghost touches that look like a board problem. In the oven, we measure temperature with a probe against the setting. You get a written price first, and a 30-day workmanship warranty follows the repair.

Key features

  • Master Series induction range that fits a 30-inch opening
  • Four induction zones, with a bridge function
  • Italian-designed, with matte or gloss finishes
  • True European convection oven
  • Triple-glazed door keeps the outside cooler
→Codes

Error codes this model can show

MAS304INMXVMAS304INMXV questions
Why does my induction zone keep turning itself off and on?

The zone is likely protecting its electronics from heat or losing contact with the pan. We test with a flat pan of the right size, then check cooling airflow and the power module that drives the zone.

What makes the touch panel register touches I did not make?

Spilled liquid or a film of cleaner on the glass can mimic a finger. We clean and dry the panel first, and if the behavior continues, we inspect the control board connections behind the glass.

Can the bridge zone be repaired without replacing the whole top?

Often, yes. The bridge relies on two zones and their driver, so we test each one separately. Only the part that has failed needs replacing, which is usually a module or a connection rather than the glass surface.

Book a visit

Book repair for your MAS304INMXV

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

☎ Call the desk ▤ Reserve a Visit