Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Bertazzoni specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 366-4775 Reserve a Visit
Model library · Bertazzoni Range

MAST244CEMXB

Bertazzoni MAST244CEMXB Electric Range Service

Bertazzoni range

Most common issues on this model

  1. A zone that never warms while the rest do
  2. Element switching on and off more often than it should
  3. Hairline crack running through the ceramic glass
  4. Zone switch catching between positions
  5. Broiler element open

Because the MAST244CEMXB is only 24 inches wide and counter-deep, it is typically fitted in a small kitchen or a secondary space where it must sit flush with the worktop. It runs entirely on electricity, so there is no gas connection to worry about.

A single cold radiant zone is usually the first thing people notice. We check the element’s resistance and the zone switch, which is the part that most often sticks or burns. If an element cycles faster than it should, the limiter inside it is a likely cause, and we test that before ordering anything.

We also look over the ceramic panel for cracks, because a hairline can spread with heat and should be handled promptly. The oven broiler is tested for continuity. You will have the price in writing before any part is ordered.

Key features

  • Master Series, 24 inches wide, freestanding electric
  • Ceramic radiant top with four zones under one glass panel
  • A knob for every zone
  • Electric broiler, convection optional
  • Counter-deep maintop that lines up with the worktop
→Codes

Error codes this model can show

MAST244CEMXBMAST244CEMXB questions
Why is one burner on my ceramic top completely cold?

The element may have burned open, or the zone switch may have failed. We measure the element and the switch separately, so we replace only the part that is bad.

I found a thin crack in the glass. Can I keep using it?

Stop using the range until we have looked at it. Cracks can let spills reach the wiring and tend to grow with heat. We inspect the panel and the elements, then replace the glass top if needed.

The zone control feels stuck between settings. What do you do?

The zone switch has an internal contact that can wear or seize. We remove the knob, test the switch, and replace it, which usually brings back the full range of heat settings.

Book a visit

Book repair for your MAST244CEMXB

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

☎ Call the desk ▤ Reserve a Visit