Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Bertazzoni specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 366-4775 Reserve a Visit
Model library · Bertazzoni Range

MAS304GASXE

Bertazzoni MAS304GASXE Gas Repair

Bertazzoni range

Most common issues on this model

  1. Burner will not light or relights with a delay
  2. Oven igniter glows but the flame is slow to appear
  3. Burner flame is tall, yellow or lopsided
  4. Oven door does not close squarely

This 30-inch Master Series range is gas from cooktop to oven, which makes it one of the simplest layouts in the line and a common choice for homes with an existing gas stub behind the wall. It slides into the standard 30-inch opening between cabinets and works hard in family kitchens.

Years of daily use mostly wear the same few parts. Burner caps get knocked out of alignment, igniters collect residue, and the oven igniter weakens until the safety valve opens late. Our first pass is a visual check of each burner, followed by a timed oven ignition and a look at the door hinges and gasket.

If you smell gas, get everyone out and call the gas utility from a safe place. Afterward we are happy to take over with a written quote and a 30-day workmanship warranty on the repair.

Key features

  • 30-inch freestanding range
  • Four gas burners
  • Gas oven
  • Master Series
→Codes

Error codes this model can show

MAS304GASXEMAS304GASXE questions
The oven igniter on my range glows but the oven never lights. Why?

The igniter has to draw enough current to open the safety valve. When it glows but is weak, the valve stays shut. We measure the draw and replace the igniter if it falls short; that is the standard fix.

Should the flames on my four burners all look the same?

They should be steady and blue, with the small burner lower than the large one. A tall or yellow flame points to a dirty port or misplaced cap. We clean and reseat them and adjust the air mix when needed.

Is it normal for the range to click after the burner is already lit?

No. Continued clicking means the spark module sees a flame it cannot confirm, often from moisture or a dirty igniter. We dry and clean it first; if clicking continues, the module is next to test.

Book a visit

Book repair for your MAS304GASXE

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

☎ Call the desk ▤ Reserve a Visit