Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Bertazzoni specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 366-4775 Reserve a Visit
Model library · Bertazzoni Refrigerator

REF36FDFIXNV

Bertazzoni REF36FDFIXNV French Door Repair

Bertazzoni refrigerator

Most common issues on this model

  1. Sensor trouble unbalancing the sides
  2. Ice maker jamming or stalling
  3. Water filter housing leaks
  4. Seals hurting temperature stability

The REF36FDFIXNV is a 36-inch French door refrigerator from the Professional Series, with a stainless steel finish and a dispenser on the outside of the door. It typically anchors a kitchen next to a Professional Series range, with the freezer drawer at the bottom and two fresh-food doors above.

Because the dispenser is on the front, the water filter housing and the supply line are used every day. A housing that weeps at the cap, or ice that stops falling, usually starts there. Inside, the sensor tells the control how much cooling each side needs, so a sensor that reads wrong leaves one side too warm and the other too cold. Wide French doors also depend on tight gaskets to hold their temperature.

We check the filter housing, the ice path, the sensors and the seals during the first visit. The price comes in writing first, and our repair is covered by a 30-day workmanship warranty.

Key features

  • 36-inch French door refrigerator
  • Professional Series
  • Exterior ice and water dispenser
  • Humidity-controlled crisper drawers, LED interior lighting, stainless steel construction
→Codes

Error codes this model can show

REF36FDFIXNVREF36FDFIXNV questions
Why is my freezer cold while the fresh-food side is warm?

A sensor reading that has drifted or a fan that moves too little air can unbalance the sections. We measure both sides, test the sensor and fan, and check the door seals before deciding on a part.

What should I do if the filter housing drips?

Turn off the water supply to the refrigerator and place a towel under the housing. A cracked cap or a worn seal is common, and we can replace the part, reseat the cartridge and test the line under pressure.

Is it normal for the ice maker to stop between harvests?

A pause is normal while the tray refills and freezes. If the arm stays up for hours or cubes arrive small, we check the water flow and the freezer temperature to find where the cycle stalls.

Book a visit

Book repair for your REF36FDFIXNV

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

☎ Call the desk ▤ Reserve a Visit